- Clean and dry the oil pump mating surfaces.
- Install the oil pump (A).
- Install a new crankshaft oil seal in the oil pump (see step 12 on page 8-11).
- Apply liquid gasket, part No. 08C70-K0234M, 08C70-K0334M or 08C70-X0331S, evenly to the block mating surface of the oil pump and to the inner threads of the bolt holes.
- Grease the lip of the oil seal and apply oil to the new O-ring (B).
- Install the dowel pins (C), then align the inner rotor with the crankshaft and install the oil pump.
- Clean the excess grease off the crankshaft and check the seal for distortion.
- Install the oil screen (D) with a new gasket (E).
- Install the oil pan (see page 7-24).
| |
Aluminium Oil Pan Type:
- Clean and dry the oil pan mating surfaces and bolt holes.
- Apply liquid gasket, part No. 08C70-K0334M or 08C70-X0331S, evenly to the oil pan mating surface of the block and to the inner threads of the bolt holes.
NOTE:
- Apply liquid gasket 4 mm wide.
- Apply liquid gasket doubly to the jointing point of the liquid gasket.
- Apply liquid gasket along the broken line.
- Install the oil pan.
- Tighten the bolts in 2 or 3 steps. In the final step, tighten all bolts, in sequence to 12 Nm (1.2 kgf/m, 8.7 lbf/ft).
- After assembly, wait at least 30 minutes before filling the engine with oil.
|