Multiplex Control System

Troubleshooting

22-273  

Special Tool Required:

MPCS Service Connector 07WAZ-0010100

  1. Check the No. 9 (10 A) fuse in the under - hood fuse/relay box and the No. 10 (7.5 A) fuse in the under-dash fuse/relay box.

Are the fuses OK?

YES – Go to step 2.

NO – Find and repair the cause of the blown fuse.

  1. Remove the dashboard lower cover (see page 20-75).
  2. Turn the ignition switch ON (II).
  3. Check self-diagnosis function Mode 1 for a diagnostic trouble code (DTC) by connecting the special tool (A) to the multiplex control inspection connector (B). After about 5 seconds, the spotlight and ceiling light should come on then blink 0.2 second. This means that you are in Mode 1 of the self-diagnosis function.

  1. If there is a DTC, it will blink, pause, then repeat the DTC as long as the ignition switch is ON (II).

Is there a repeating DTC?

YES – Count the blinks, then go to step 8.

NO – See if the SCS circuit is working properly. Go to step 6.

  1. Check for continuity between the inspection connector T1 and T3 terminals.

Is there continuity?

YES – Go to step 7.

NO – Faulty under-dash fuse/relay box, replace it and recheck for DTCs.

  1. Check for continuity between the connector J of under - dash fuse/relay box No. 4 terminal and body ground.

Is there continuity?

YES – Go to step 9.

NO – Repair the open in the wire and recheck for DTC's.