Cavity Wire Connects to 1*¹ YEL/GRN Roof antenna 2 YEL/RED ACC (Main stereo power supply) 3 ——— Not used 4*² RED/WHT Security signal input 5 PNK Right rear[door]speaker (+) 6 BLU/WHT Left rear [door] speaker (+) 7 GRN/YEL Right front door speaker (+) 8 GRN/BLK Left front door speaker (+) 9 RED/BLK Lights - on signal 10 WHT/RED Constant power 11 ——— Not used 12 ——— Not used 13 ——— Not used 14 ——— Not used 15 BLU/YEL Right rear [door] speaker ( – ) 16 BLU/BLK Left rear [door] speaker ( – ) 17 GRY/RED Right front door speaker ( – ) 18 LT GRN Left front door speaker ( – ) 19*³ RED Dash lights brightness controller 20 BLK Ground (G503) [ ]: 5-door *1: 5-door with roof antenna *2: With security alarm system *3: With dash lights brightness controller AUDIO UNIT 20P CONNECTOR

NOTE: Put on gloves to protect your hands. Take care not to scratch the dashboard and related parts. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons. Remove the dashboard centre lower cover (see page 20-77). Remove the heater control panel (or climate control unit) (see page 21-51) from the centre panel. Remove the four mounting bolts and the audio unit from the radio brackets. Install the audio unit in the reverse order of removal and note these items: Make sure the audio unit and A/C connectors are plugged in properly and the antenna lead is connected properly. Enter the anti-theft code for the radio, then enter the customer's radio station presets.