Fuel and Emissions Systems

Symptom Troubleshooting Index

11-471  

When the vehicle has one of these symptoms, check the Diagnostic Trouble Code (DTC). If there is no DTC, do the diagnostic procedure for the symptom, in the sequence listed, until you find the cause.

Symptom

Diagnostic procedure

Also check for

Engine will not start (MIL works OK, no DTCs set)

  1. Test the battery (see page 22-79).
  2. Test the starter (see page 4-8).
  3. Troubleshoot the fuel pump circuit (see page 11-562).
  • Low compression
  • Intake air leaks
  • Locked up engine
  • Slipped/broken timing belt
  • Contaminated fuel

Engine will not start (MIL comes on and stays on, or never comes on at all, no DTCs set)

Troubleshoot the MIL circuit (see page 11-540).

 

Engine will not start*1 (immobiliser indicator light comes on)

Troubleshoot the immobiliser system (see page 22-245).*1

 

Hard starting (MIL works OK, no DTCs set)

  1. Test the battery (see page 22-79).
  2. Check the fuel pressure (see page 11-431).
  • Low compression
  • Intake air leaks
  • Contaminated fuel

When cold fast idle out of spec (MIL works OK, no DTCs set)

  1. Check the idle speed (see page 11-560).
  2. Inspect/adjust the throttle cable (see page 11-449).
  3. Inspect and test the throttle body (see page 11-574).

 

After warming up idle speed is below specifications with no load (MIL works OK, no DTCs set)

  1. Troubleshoot the ALT FR signal circuit (see page 11-420).
  2. Inspect and test the throttle body (see page 11-574).

Vacuum hose clogged/cracked/poor connection

After warming up idle speed is above specifications with no load (MIL works OK, no DTCs set)

Troubleshoot the ALT FR signal circuit (see page 11-420).

 

After warming up idle speed fluctuates with electrical load (MIL works OK, no DTCs set)

  1. Troubleshoot the ALT FR signal circuit (see page 11-420).
  2. Inspect and test the throttle body (see page 11-574).
  • Vacuum hose clogged/cracked/poor connection
  • A/C system

After warming up idle speed drops when steering wheel is turning (MIL works OK, no DTCs set)

  1. Troubleshoot the PSP switch signal circuit (see page 11-558), (the EPS signal circuit: (see page 11-422)*1.
  2. Inspect and test the throttle body (see page 11-574).

Power steering system

Idle speed fluctuates (MIL works OK, no DTCs set)

  1. Test the fuel pressure (see page 11-431).
  2. Test the injectors (see page 11-552).
  3. Troubleshoot the ALT FR signal circuit (see page 11-420).
  4. Inspect and test the PCV valve (see page 11-459).
  • Contaminated fuel

*1: with TWC model