DTC P0335: - CKP Sensor No Signal
DTC P0336: |
- CKP Sensor Intermittent Interruption |
- Reset the ECM/PCM (see page 11-312).
- Start the engine.
Is DTC P0335 and/or P0336 indicated?
YES |
- Go to step 3. |
NO |
- Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the CKP sensor and at the ECM/PCM. |
- Turn the ignition switch OFF.
- Disconnect the CKP sensor 3P connector.
- Turn the ignition switch ON (II).
- Measure voltage between the CKP sensor 3P connector terminal No. 3 and body ground.
CKP SENSOR 3P CONNECTOR
Wire side of female terminals
Is there battery voltage?
YES |
- Go to step 7. |
NO |
- Repair open in the wire between the PGM-FI main relay 1 and the CKP sensor. |
| |
- Measure voltage between the CKP sensor 3P connector terminal No. 1 and body ground.
CKP SENSOR 3P CONNECTOR
Wire side of female terminals
Is there about 5 V?
YES |
- Go to step 8. |
NO |
- Go to step 10. |
- Measure voltage between the CKP sensor 3P connector terminals No. 2 and No. 3.
CKP SENSOR 3P CONNECTOR
Wire side of female terminals
Is there battery voltage?
YES |
- Go to step 9. |
NO |
- Repair open in the wire between the CKP sensor and G101. |
- Substitute a known-good CKP sensor and recheck.
Is DTC P0335 and/or P0336 indicated?
YES |
- Substitute a known-good ECM/PCM and recheck (see page 11-313). If symptom/indication goes away, replace the original ECM/PCM. |
NO |
- Replace the original CKP sensor. |
|