DTC 11-4: Short to Power in Driver's Side Airbag Inflator (With OPDS Unit Model)
- Erase the DTC memory (see page 23-38).
- Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures (see page 23-38).
- Turn the ignition switch OFF. Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the SDi connector (A) from the driver's side airbag (B).
- Connect the special tool (2 ohm) to the SDi connector.
| |
- Reconnect the battery negative cable.
- Erase the DTC memory.
- Read the DTC.
Is DTC 11-4 indicated?
YES - Go to step 9.
NO - Short to power in the driver's side airbag inflator; replace the driver's side airbag.
- Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the SPi connector (A) from the front passenger's side airbag (B), and disconnect the special tool (2 ohm) from the SDi connector.
- Disconnect the U2o connector (A) from the SRS unit (B).
|