DTC 1-4: Short to Power in Driver's Airbag Inflator
- Erase the DTC memory (see page 23-38).
- Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures (see page 23-38).
- Turn the ignition switch OFF. Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the D1o connector from the D1i connector (A).
- Connect the special tool (2 ohm) to the D1i connector.
- Reconnect the battery negative cable.
- Erase the DTC memory.
| |
- Read the DTC.
Is DTC 1-4 indicated?
YES - Go to step 9.
NO - Short to power in the driver's airbag; replace the driver's airbag (see page 23-165).
- Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the P1o connector (A) from the P1i connector (B).
- Disconnect the TL1o and TR1o connectors (A) from the TL1i and TR1i connectors (B).
|