DTC 11-1: Open or Increased Resistance in Left Side Airbag Inflator (Without OPDS Unit Model)
- Erase the DTC memory (see page 23-38).
- Turn the ignition switch ON (II), and check that the SRS indicator light comes on for about 6 seconds and then goes off.
Does the SRS indicator light stay on?
YES - Go to step 3.
NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures (see page 23-38).
- Turn the ignition switch OFF. Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the SLi connector (A) from the left side airbag (B).
- Connect the special tool (2 ohm) to the SLi connector.
| |
- Reconnect the battery negative cable.
- Erase the DTC memory.
- Read the DTC.
Is DTC 11-1 indicated?
YES - Go to step 9.
NO - Open or increased resistance in the left side airbag inflator; replace the left side airbag.
- Disconnect the battery negative cable and wait for 3 minutes.
- Disconnect the SRi connector (A) from the right side airbag (B).
- Disconnect the U2o connector (A) from the SRS unit (B). Do not disconnect the special tool (2 ohm) from the SLi connector.
|