4-door Model Remove the transmission range switch harness connector (A) from the connector bracket (B), then disconnect the connector. Connector Terminal Description No. Description No. Description 1 GND 6 2 S 7 3 ATP NP 8 4 9 5 10 Check for continuity between terminals at the harness connector. There should be continuity between the terminals listed for each switch position. In position, between terminals: No. 1 and No. 3 No. 1 and No. 8 No. 3 and No. 8 In position, between terminals: No. 1 and No. 9 In position, between terminals: No. 1 and No. 3 No. 1 and No. 10 No. 3 and No. 10 In position, between terminals: No. 1 and No. 2 No. 1 and No. 4 No. 2 and No. 4 In position, between terminals: No. 1 and No. 2 No. 1 and No. 5 No. 2 and No. 5 In position, between terminals: No. 1 and No. 6 In position, between terminals (7-position): No. 1 and No. 7

If there is no continuity between any terminal, remove the transmission range switch cover and disconnect the connector (A) at the switch (B). Connector Terminal Description No. Description No. Description 1 6 2 7 3 8 4 GND 9 5 ATP NP 10 S Check for continuity between terminals at the switch connector (C). There should be continuity between the terminals listed for each position. In position, between terminals: No. 4 and No. 5 No. 4 and No. 6 No. 5 and No. 6 In position, between terminals: No. 1 and No. 4 In position, between terminals: No. 4 and No. 5 No. 4 and No. 7 No. 5 and No. 7 In position, between terminals: No. 2 and No. 4 No. 2 and No. 10 No. 4 and No. 10 In position, between terminals: No. 4 and No. 8 No. 4 and No. 10 No. 8 and No. 10 In position, between terminals: No. 3 and No. 4 In position, between terminals (7-position): No. 4 and No. 9 If there is no continuity between any terminals, check the transmission range switch installation. If the transmission range switch installation is OK, replace the switch. If the transmission range switch continuity check was OK, replace the faulty transmission range switch harness.