Automatic Transmission

Interlock System - Shift Lock System Circuit Troubleshooting (cont'd)

14-103  

  1. Disconnect the TPS (throttle position sensor) connector.
  1. Turn the ignition switch ON (II).
  2. Measure the voltage between the No. 1 and No. 3 terminals of the TPS connector.

TPS CONNECTOR

Wire side of female terminals

Is there about 5 V?

YES - Check for an open or a short in the wire between PCM connector terminal A15 and the TPS. If wire is OK, replace the TPS.

NO - Go to step 20.

  1. Turn the ignition switch OFF.
  2. Disconnect PCM connector A (31P).
  3. Check for continuity between the No. 1 terminal of TPS connector and body ground and between the No. 3 terminal and body ground.

TPS CONNECTOR

Wire side of female terminals

Is there continuity?

YES - Check for a short to ground in the wires between the No. 1 and No. 3 terminals of TPS connector and ground. If the wires are OK, replace the PCM.

NO - Go to step 23.

  1. Reconnect the PCM connector A (31P) and TPS connector.
  2. Disconnect the shift lock solenoid/D3 switch connector.
  3. Turn the ignition switch ON (II).
  4. Press the brake pedal and measure the voltage between No. 1 terminal of the shift lock solenoid/D3 switch connector and body ground.

SHIFT LOCK SOLENOID/D3 SWITCH CONNECTOR

Wire side of female terminals

Is there battery voltage when pressing the brake pedal?

YES - Go to step 27.

NO - Repair open or short in the wire between the No. 1 terminal of the shift lock solenoid/D3 switch connector and the multiplex control unit.