DTC 13: BARO Sensor Circuit Malfunction Reset the ECM/PCM (see page 11-168). Turn the ignition switch ON (II). Is the MIL on and does it indicate DTC 13? YES - Substitute a known-good ECM/PCM and recheck. If symptom/indication goes away, replace the original ECM/PCM. NO - Intermittent failure, system is OK at this time (test-drive may be necessary).

DTC 17: VSS Circuit Malfunction Reset the ECM/PCM (see page 11-168). Test-drive with no load (in Park or neutral), accelerate to 4,000 rpm (min-1), then decelerate to 1,500 rpm (min-1) with throttle fully closed for at least 5 seconds. Is the MIL on and does it indicated DTC 17? YES - Go to step 3. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the VSS and at the ECM/PCM. Turn the ignition switch OFF. Block the rear wheels and set the parking brake. Raise the front of the vehicle, and make sure it is securely supported. Turn the ignition switch ON (II). Block the right front wheel, and slowly rotate the left front wheel. Measure voltage between ECM/PCM connector terminals A18 and A24. ECM/PCM CONNECTOR A (31P) Wire side of female terminals Does the voltage pulse between 0 V and 5 V (or battery voltage)? YES - Substitute a known-good ECM/PCM and recheck. If symptom/indication goes away, replace the original ECM/PCM. NO - Go to step 9.