DTC P1519: IAC Valve Circuit Malfunction Reset the ECM/PCM (see page 11-4). Turn the ignition switch ON (II). Is DTC P1519 indicated? YES - Go to step 3. NO - Intermittent failure, system is OK at this time. Check for poor connections or loose wires at the IAC valve and at the ECM/PCM. Turn the ignition switch OFF. Disconnect the IAC valve 3P connector. Turn the ignition switch ON (II). Measure voltage between the IAC valve 3P connector terminal No. 2 and body ground. IAC VALVE 3P CONNECTOR Wire side of female terminals Is there battery voltage? YES - Go to step 7. NO - Repair open in the wire between the IAC valve and the PGM-FI main relay. Turn the ignition switch OFF.

Check for continuity between body ground and IAC valve 3P connector terminal No. 1. IAC VALVE 3P CONNECTOR Wire side female terminals Is there continuity? YES - Go to step 9. NO - Repair open in the wire between the IAC valve and G101. Disconnect ECM/PCM connector A (31P). Check for continuity between body ground and ECM/PCM connector terminal A12. ECM/PCM CONNECTOR A (31P) Wire side of female terminals Is there continuity? YES - Repair short in the wire between the IAC valve and the ECM/PCM (A12). NO - Go to step 11.