PGM-FI System

MIL Circuit Troubleshooting (cont'd)

11-79  

  1. Turn the ignition switch OFF.
  1. Inspect the No. 6 ECU (ECM) (15A) fuse in the under-hood fuse/relay box.

    Is the fuse OK?

YES - Go to step 29.

NO - Go to step 23.

  1. Remove the blown No. 6 ECU (ECM) (15A) fuse in the under-hood fuse/relay box.
  1. Remove the PGM-FI main relay 1 (A).

LHD model:

RHD model:

  1. Check for continuity between body ground and the PGM-FI main relay 14P connector terminals No. 2 and No. 4 individually.

Is there continuity?

YES - Repair short in the wire between the No. 6 ECU (ECM) (15A) fuse and the PGM-FI main relay 1. Also replace the No. 6 ECU (ECM) (15A) fuse.

NO - Go to step 26.

  1. Disconnect each of the components or the connectors below, one at a time, and check for continuity between the PGM-FI main relay 1 4P connector terminal No. 1 and body ground.
  • PGM-FI main relay 2
  • ECM connector A (31P)
  • Each injector 2P connector
  • Idle air control (IAC) valve 3P connector
  • Top dead centre (TDC) sensor 3P connector
  • Crankshaft position (CKP) sensor 3P connector