- Connect the ECM connector terminal A5 and B1 with a jumper wire for below 1 minute.
NOTE: Do not jump for above 1 minute.
ECM CONNECTORS
Wire side of female terminals
Did the engine stall or run rough?
YES - Test-drive at a steady speed between 30 - 60 km/h (19 - 37 mph) for 10 minutes.
If temporary DTC P0011 is indicated, substitute a known-good ECM and recheck (see page 11-5), replace the original ECM. 
NO - Go to step 15.
- Check the VTC actuator (see page 6-9).
Is the VTC actuator OK?
YES - Remove the auto-tensioner (see page 4-26) and replace the VTC oil filter. Substitute a known-good ECM and recheck (see page 11-5). If symptom/indication goes away, replace the original ECM.
NO - Replace the VTC actuator.
