| NOTES |
SECTION and PAGE |
| |
(see page 8-3) |
| |
(see page 8-6)*1 |
| |
(see page 11-147)*1 (see page 11-447)*1 |
| Check the valve clearance. |
(see page 6-14)*1 |
| |
(see page 11-138)*1 (see page 11-296)*1 (see page 11-438)*1 (see page 11-571)*1 |
| |
(see page 4-22) |
| Check water pump for signs of seal leakage. |
(see page 6-18)*1 (see page 6-22)*1 (see page 10-7)*1 |
- Check for cracks and damage.
- Check deflection and tension.
|
(see page 17-23)*1 |
| |
(see page 11-125)*1 (see page 11-285)*1 (see page 11-425)*1 (see page 11-560)*1 |
| Check specific gravity for freezing point. |
(see page 10-8)*1 |
| Use genuine Honda MTF (Manual Transmission Fluid). |
(see page 13-3)*1 |
| Use genuine Honda AFT-Z1 (ATF). |
(see page 14-122)*1 |
- Check the brake pad and disc thickness. Check for damage or cracks.
- Check the wheel cylinder for leaks.
- Check the brake linings for cracking, glazing, wear or contamination.
- Check the callipers for damage, leaks and tightness.
|
(see page 19-3)*1 |
| Use only DOT 3 or DOT 4 brake fluid. (We recommend Genuine Honda Brake Fluid.) Check that Brake fluid level is between the upper and lower marks on the reservoir. |
(see page 19-7)*1 |
| Check the parking brake operation. |
(see page 19-6)*1 |
| |
- |
| Check the position of the headlight. |
(see page 22-114)*1 |
| Check for road stability, noise, vibrations and dashboard operation. |
- |
- Check for correct installation and position, check for cracks, deterioration rust and leaks.
- Check tightness of screws, nuts and joints. If necessary, retighten.
|
- |
| Check rack grease and steering linkage. Check the boot for damage and leaking grease. |
(see page 17-5)*1 |
- Check the bolts for tightness.
- Check all the dust covers for deterioration and damage.
|
(see page 18-3)*1 |
- Check the boot and boot band for cracks
- Check rack grease.
|
(see page 16-3)*1 |
| Check the master cylinder, proportioning control valve and ABS modulator and leakage. |
(see page 19-48)*1 |
| Check for leaks. |
- |
| Check the catalytic converter heat shield, exhaust pipe and muffler for damage, leaks and tightness. |
(see page 9-3) |
| Check fuel lines for loose connections, cracks and deterioration. Retighten loose connections and replace any damaged parts |
(see page 11-132)*1 (see page 11-290)*1 (see page 11-432)*1 (see page 11-565)*1 |
| Check for pressure, puncture or cuts and irregular tread wear. |
- |
*1: Refer to the Shop manual on this CD: '01 CIVIC MAINTENANCE, REPAIR and CONSTRUCTION Code No. 62S5A00
